top of page

Occupancy-based lighting control for offices and commercial buildings

7 hours ago
2 min read

Plan a metered lighting pilot by zone, compare the WS202 sensor and WS558 controllers, and specify a bill of materials for a multi-site rollout.

International deployment

25% less lighting energy within one month in Dubai

Milesight reports a 25% reduction in lighting energy within one month across its Dubai office-building example. The installation combined occupancy sensing, scheduled control and a gateway. The figure applies to lighting energy in that deployment.

Suggested Australian pilot

Select one occupied office zone with a separately measurable lighting circuit. Record lighting kWh, staffed hours, scheduled operating hours and overrides before the trial. After commissioning, compare equivalent working weeks and record changes in occupancy or daylight.

Report lighting kWh per staffed hour alongside total kWh. Record occupant complaints and manual overrides so a reduction can be assessed alongside service quality.

Equipment and engineering scope

The WS202 senses occupancy and light. The WS558 controls lighting circuits. Switch and LN are different catalogue variants. Have the project electrician confirm circuit design, loads, manual override and gateway coverage before ordering. A sensor purchase alone does not enable switching.

Select equipment for your site

Start with the occupancy sensor to understand use of the space. For automatic switching, ask for a zone-by-zone control design.

Individual components from ProSense Instruments

Engineering and wholesale quotations

Provide a lighting circuit schedule, load details, existing controls, required overrides and the metering point for the trial.

Specify the WS558 variant, sensors per zone, gateways, spares, staged quantities and delivery dates.

bottom of page