.png)
Compressor Pressure Cycling: Planning a LEFOO Switch Application
Publisher: ProSense Solutions | AI-assisted application commentary | Sources checked 2 November 2026
A practical LEFOO application brief covering compressor pressure-cycle requirements and control boundaries.
Source type: Manufacturer application guide. LEFOO's pressure-switch selection guide discusses operating range, sensing mechanism, electrical rating and process connection. The following compressor scenario is ProSense application commentary, not a reported installation.
Begin with the pressure cycle
A pressure-switch application is defined by when a signal should change state and when it should reset. Describe the normal operating cycle, the required cut-in and cut-out conditions, and what the receiving circuit does with that signal. Those requirements should be recorded before selecting or adjusting equipment.
Separate a process symptom from a switch fault
If a compressor starts unusually often, collect a time record of pressure and operating state before concluding that the switch is responsible. Air demand, leakage, receiver capacity, control settings and the measurement arrangement can all affect the observed cycle. A replacement should follow diagnosis by the appropriate service person.
Make the control boundary clear
A switch contact is an electrical interface, not a complete compressor-control system. Confirm the circuit it is intended to operate and the relevant load characteristics. The selected control arrangement must account for the compressor manufacturer's requirements, existing protection and any separate unloading function.
Prepare an acceptance record
For a proposed installation, the qualified installer should record the exact model, applicable setpoints, observed switching behaviour and the reference instrument used. Check repeatability over representative operating cycles and retain the settings with the equipment record. This guide does not authorise live adjustment or replacement of a safety device.
Information to bring to ProSense
Supply the existing model code and wiring information, operating pressure range, medium, connection thread, installation environment and the intended switching function. Explain the observed problem separately from the requested replacement so the equipment brief can be reviewed without assuming the diagnosis.
Manufacturer reading and related equipment
Discuss your requirements with ProSense Solutions: 1800 560 854 | sales@prosense.com.au. Send the process conditions, current equipment details and required result.
